Morley Line Level Shifter – 2 Channel Box, XLR/TRS

Beschreibung

The primary function of the Morley Line Level Shifter is to increase or decrease signal voltage back and forth between -10 dBu and +4 dBV (depending on which way you route through it). The Line Level Shifter also breaks loop antenna that causes ground hum and buzz, as well as converting back and forth between balanced and unbalanced connections and preventing the cable to act as an antenna for noise. Simply place a channel of the Line Level Shifter on the cable connections between the two mismatching pieces of equipment. The Line Level Shifter will not affect the quality of the audio, it will improve it. Morley uses 1/4″ (6.3 mm) smart jacks that accept any combination of unbalanced (TS) or balanced (TRS) plugs. These are passive devices (no power required), in cold rolled steel housings, hand-soldered circuit boards and top quality components and hardware.
– 2-channel Line Level Shifter
– 1/4″ (6.3 mm) Smart Jacks and XLR jacks
– converts signal voltage back and forth between -10 dBu and +4 dBV
– prevents ground loops that cause hum and buzz
– passive operation (no power supply required)
– frequency response 10 Hz to 40 kHz at +/- 1 dB
– distortion less than 0.002% THD @ 1 kHz
– crosstalk better than -97 dB
– max. source impedance 1 kOhm, min. load impedance 10 kOhm
– dimensions (L x W x H) 120 x 82 x 44 mm / 4.75″ x 3.25″ x 1.75″
– Made in USA